Awning Installation Precautions
Published Time:
2021-11-12
1. Before installation, check if the dimensions and allowance of the board are appropriate. Ensure sufficient expansion gap is left. The expansion calculation formula is: expansion coefficient * board length * the largest temperature difference between installation and use = total expansion gap
1. Before installation, check if the dimensions and allowance of the board are appropriate. Ensure sufficient expansion gap is left. The expansion calculation formula is: expansion coefficient * board length * the largest temperature difference between installation and local ambient temperature = total expansion gap
2. When tightening self-tapping screws, maintain even force. The board and sealing strip must be pressed firmly, but avoid excessive force that could damage them.
3. After installing the board, remove the protective film. Before installation, peel back the protective film around 50mm on all sides to prevent it from being trapped during installation.
4. After installation, perform an inspection using a spray test to check for leaks. The test process must be thorough. Carefully observe each part, and address any potential leaks immediately to prevent minor issues from becoming major problems.
More Information
Address: No. 8 Yangpu Road, Haian Economic and Technological Development Zone
Email: th@zgjsthzg.com
Tel: 86-513-88744899
Postcode: 226601
Mobile Websites